VA 520 - Thermal mass flow meter for flow measurement
for compressed air and gases. New digital electronics - improved accuracy.
Details
- All wetted parts are made of stainless steel, especially for applications with high demands on cleanliness and surface quality
- Robust aluminium housing enables use in harsh industrial environments
- Recommended for flammable gases such as Natural gas, hydrogen, Biogas, etc. due to ATEX or DVGW approval
- Measuring the mass flow, direct output of the Standarized volume flow
- Highly accurate for both small and large flows
- Pressure and temperature-compensated thanks to the thermal mass flow principle
- Quick and easy installation via a standard ½'' Ball valve
- No moving parts, therefore Low maintenance
- Disappearingly low pressure loss, as the blockage of the diameter is negligible
- 04...20 mA, pulse and a Modbus RTU (RS 485) interface as standard, optional interfaces such as Modbus TCP (Ethernet), PoE, M-Bus
- Pressure range up to 50 bar, special version up to 100 bar
- Media temperature range up to 180 °C (ATEX version up to 120 °C)
- Protection class IP 67 (IP 64 for ATEX II 2D Ex tb IIIC T90°C Db)
- Integrated display for showing the Measured values
- Suitable as insertion version for 3/4" to DN 1000
- Simple installation under pressure
- Settings can be adjusted using the buttons on the display
- Main counter reading can be reset via the Display
- For Velocities up to 224 Nm/s
- Highly accurate with an Accuracy of ± 1.5% or ± 1% of the Measured value - As well as ± 0.3 % of the final value
V.01
Similar products
VA 500 - Flow meter for compressed air and gases
RS 485 interface, Modbus RTU, 4...20 mA analogue output for m³/h, Pulse output for m³.
VA 570 - Thermal mass flow meter for consumption measurement
ATEX approval for hazardous areas and DVGW approval for use in natural gas.
PI 500 for e.g. portable flow measurement
The PI 500 is an all-purpose hand-held measuring instrument for many applications in the industry.
Accessories
Spot drilling collars
If there is no measuring site with 1/2" ball valve present it can be set up by means of spot drilling collars.
Drilling jig for set up a measuring site
By means of a special drilling device a measuring site with 1/2" ball valve can be easily set up within a few minutes.
High-pressure protection
The supplementary device "high-pressure protection" serves for a safe installation and fastening of the CS sensors VA 500 under pressure.
Thickness meter CS 0495
enables a quick, easy and accurate measurement of the wall thickness of pipes.