Measuring chamber for granulate dryers and gases

During transport and storage, the plastic granules absorb moisture. If the plastic is not optimally dried during processing, this has a variety of negative effects on the end product. Bubbles or streaks on the surface or the dimensional accuracy is not given. The measuring chamber for granulate dryers can be easily connected to the granulate dryer via a Teflon line. During drying, the dew point should be in the range of -30...-60 °C. Process connection G ¼" female thread for connection to the process air. G ½" thread for connection of the dew point sensor. The measuring chamber can be used from -1 to 16bar.

  • Applicable for -1...16 bar
  • Process connection: Plug connection for 6 mm hose at inlet and outlet or G 1/4" female thread when using without plug connections
  • Sensor connection: G 1/2" female thread
  • The flow of at least 2 liters / min of air / gas must be ensured by the customer

Order No. 0699 3490

to the request

The product has been added to the request.
to the request

Similar products

DP 510 - Portable dew point meter with third-party sensor

Disposes all functions of our DP 500 and comes with an additional - freely assignable - sensor input.

More

FA 510/515 - Dew point sensor for adsorption dryers

For residual moisture measurement after desiccant dryers/ membrane dryers from -80 to 20°Ctd. New: with Modbus-RTU interface.

More

FA 510/515 - Dew point sensor for refrigeration dryers

Dew point measurement from -20 to 50°Ctd. New: with Modbus-RTU interface.

More

Dew point measurement DS 52-set for desiccant dryers

with the digital process meter DS 52 and the dew point sensor FA 510 with a measuring range from -80 to 20°Ctd.

More