Measuring chamber for granulate dryers and gases

Plastic granules absorb moisture during transport and storage. If the plastic is not optimally dried during processing, this has a variety of negative effects on the end product. Bubbles or streaks appear on the surface or the dimensional accuracy is not guaranteed. The measuring chamber for granulate dryers can be easily connected to the granulate dryer via a Teflon line. During drying, the Dew point should be in the range of -30...-60 °C. Process connection G ¼" internal thread for connection to the process air. The G ½" thread for connecting the Dew point sensor. The measuring chamber can be used from -1 to 16 bar.

  • Can be used from -1...16 bar
  • Process connection: Push-in connection for 6 mm hose at inlet and outlet or G 1/4" internal thread when used without push-in connections
  • Sensor connection: G 1/2" female thread
  • The flow rate of at least 2 litres/min of air/gas must be ensured on site

Order no. 0699 3490

to the inquiry

The product has been added to inquiry.
to the inquiry

Similar products

DP 510 - Portable dew point meter with third-party sensor

Combines all the functions of the DP 500 with an additional, freely assignable sensor input.

More

FA 510/515 - Dew point sensor for adsorption dryers

For residual moisture measurement from -80 to 20°Ctd. New: With Modbus RTU interface.

More

FA 510/515 - Dew point sensor for refrigeration dryers

for measuring residual moisture from -20 to 50°Ctd. New: With Modbus RTU interface.

More

Dew point measurement DS 52-set for desiccant dryers

with the process display DS 52 and the Dew point sensor FA 510 with a Measuring range of -80...20°Ctd.

More