Measuring chamber for atmospheric dew point

Measuring chamber for atmospheric dew point

With the measuring chamber for measuring the atmospheric dew point, the pressure inside the measuring chamber is reduced to atmospheric pressure. Especially in medical applications, the dew point measurement must be carried out in the atmospheric pressure range.

Medical compressed air has been subject to the German Medicines Act since 01.08.01. Until then, the requirements for medical compressed air were specified in DIN EN 737-3.
The monograph "Aer medicinalis" in the Addendum to the European Pharmacopoeia contains - in comparison to DIN EN 737-3 - significantly changed purity parameters, whereby in particular the drastic reduction of the dew point temperature to -46°C atmospheric (this corresponds to 67 ppm V/V) leads to considerable difficulties.
The value 67 ppm V/V for water corresponds to the condensation limit at a pressure of 200 bar and a temperature of 11 ºC. This limitation of the water content to the condensation limit is necessary because the condensation of water can cause corrosion damage and also promote the multiplication of germs.

The measuring chamber can be used from 2 to 16. Process connection G ¼" female thread for connection to the process air. G ½" thread for connection of the dew point sensor. For compressed air to flow through the dew point sensor installed in the measuring chamber, approx. 2-3 l/min of process air is delivered to the environment via the built-in nozzle.

Order no.: 0699 3690

to the request

The product has been added to the request.
to the request

Similar products

Portable dew point meter DP 510 with third party sensor

DP 510 - Portable dew point meter with third-party sensor

Disposes all functions of our DP 500 and comes with an additional - freely assignable - sensor input.

More
The dew point sensors FA510/515 for the typical use in refrigeration dryers

FA 510/515 - Dew point sensor for adsorption dryers

For residual moisture measurement after desiccant dryers/ membrane dryers from -80 to 20°Ctd. New: with Modbus-RTU interface.

More
The dew point sensors FA510/515 for the typical use in refrigeration dryers

FA 510/515 - Dew point sensor for refrigeration dryers

Dew point measurement from -20 to 50°Ctd. New: with Modbus-RTU interface.

More